NEW!!  NOW AVAILABLE FOR BOTH LARGE & SMALL DIAMETER THROTTLE SHAFT AIR THROTTLES                                      

                              HALL THROTTLE POSITION SWITCHES (067 & 067A)

Our new Hall Throttle Position Switch, is now available for purchase  from the Van Cafe in Fort Collins, CO. Clicking the photo above will allow you to order our Hall TPS on their website. The Hall Switch provides idle and full throttle signals to your ECU electronically, as opposed to finicky vacuum systems, or mechanical microswitches. Your old grey cam is replaced with a Magnet Disc, containing two tiny Neodymium magnets, which activate a Hall Sensor at the two throttle shaft end points. All components are pre-mounted on a double sided printed circuit board, which is tested individually with the Magnet Disc supplied with your kit. Simply remove your old microswitch, replace it with the circuit board assembly, and make two simple connections to 12V and ground with wires & connectors provided, reconnect the two wires from your old switch, and your installation is complete. We have even provided an LED to make adjusting your new switch on installation or  later much easier. Circuit is protected against over current with a resettable fuse, and isolated from your vehicles 12V system via a 5V regulator chip. All required parts, along wth a detailed installation manual are included. A 6" T Handle 3mm Hex Wrench is also included in your kit. This wrench simplifies adjusting your TPS once it is installed.

SHOEBOX HALL THROTTLE SWITCH KITS  $74.95 (for 1986 - 1991 Digifant Vanagons)
Model 067 Hall TPS Kit (for VW air throttle part# 025 133 067 - equipped with 14mm DIA throttle shaft cam
Model 067A Hall TPS Kit (for VW air throttle part# 025 133 067A - equipped with 17mm DIA throttle shaft cam